Class Two 40FT Height Steel Electrical Power Pole 5mm Thickness For 69KV Transmission Distribution Application

Class Two 40FT Steel Electrical Power Pole 5mm Thickness For 69KV Transmission Distribution Line

Options:

• The Power Distribution Pole is available in various length, diameters and hole arrangements.

• Multisided or Tapered round variations.

• The Power Distribution Pole covers Voltage between 10-220KV.

• The Power Distribution Pole includes: suspension pole, stain pole and angle pole in different forms.

• Standard Corrosion Protection: hot dip galvanising (above and in-ground)

• Additional in-ground protection is available for special circumstances (soil condition). For example: Epoxy Coating.

• Pre-drilling for removable safety steps is available.

• Cross arms available.

Workshop Picture

Pole Type

Technical Data Sheet(F=10KN)

More details and load,feel free to call me.

Available Foundation Types

Direct Embedment

Anchor Bolt/Base Plate

Vibratory Steel Caisson

Available Finishes

Galvanized per ASTM A123

Paint over galvanized,paint over black steel

Powder Coating

Standard Features of in-ground and base plate mounted

In-Ground Mounted:

12-sided pole shaft

Welded top cap

Mounting holes (to your specification if required)

Identification plate

M12 earth point 250mm above the nominal ground line

M24 nut 250mm above the nominal ground line (to assist lifting)

Additional in-ground corrosion protection 200mm above to 400mm below the nominal ground line

Anti-sink straps

Hot dip galvanised finish

Base Plate Mounted:

12-sided pole shaft (40kN to 80kN)

16-sided pole shaft (100kN & 120kN)

Welded top cap

Mounting holes (to your specification if required)

Identification plate

M12 earth point 250mm above the pole base

Two lifting gussets on the base plate

Anchor bolts, templates, nuts & washers

Hot dip galvanised finish

The information to inquiry or purchase

- Steel pole height and force

- Cross arm type and length,the position to install in the steel pole

- The method to fix the cross arm(use bolt to connect or use one or two template to weld in the steel pole to install the cross arm)

- Safety factor of the steel pole

- Wind speed

- Type of climbing rung

- Destination port

- Other.

Pole Application:

Transmission

Distribution

Steel Substation Structure

Pole Advantage:

Power Distribution Poles are required especially in populated areas where these poles are favoured because they require less space than lattice towers and are more acceptable visually. Weighing of the steel made Power Distribution poles is approximately 50-70% less than comparable wood structures, the steel poles are easier and less expensive to handle and install.